SpeedFactory SRT-4 Titanium Stud Kits are made of ultra-strong Ti 6Al-4V and incorporate a 3mm hex key tip that allows them to be easily installed using an Allen wrench. Titanium 10mm 12-point nuts and washers are included.

Use of factory manifold bolts and studs, especially with an aftermarket intake manifold or header/turbo system, can result in stripped or broken bolts and inadequate clamping force, resulting in leaks. This stud kit looks great and will allow you to properly clamp the intake or exhaust manifold to the cylinder head without experiencing sealing problems, stud/nut failure, or ugly and troublesome rust and corrosion.

Titanium is ~45% lighter, stronger, and will not corrode like your stock steel bolts or studs!

Each stud/washer/nut assembly weighs only 11.5g!

This kit incluces the following and will work for intake or exhaust:

(10) M8 x 1.25mm x 45mm titanium studs

(10) 12-point M8x1.25mm titanium nuts

(10) M8 titanium washers

Available in standard or burnt titanium finish.

If you are not sure if these studs will work with your engine, please email us [email protected] or call us at (253)566-4331